Roland C-280P Pipe System Installation Guide
Contents
1. fasten the anti earthquake cabinet holders in the two positions indicated in the figure with screws b Hales for the screws have not been provided Screw in the screws at the appropriate places Precautions When Using the Safety Hardware Fasten the hardware to a wall with a thickness of al least 17 mm Make sure the core materia of the wall Is strong enough to withstand the weight If not the brackets should be fastened to crosspleces or other beams running through the wall Instead Thescrewsincuded with the hardware are meant to be screwed into hard wood wali core or similar material Attaching the hardware to lumber butt ends con crete walis gypsum board or other such surfaces requires the use of special hardware and screws consult your contractor or carpenter When properly Installed this hardware is extremely effective in preventing the organ and pipes from falling over However In addition to Incorrect Installation certain factors Including weakening of walls due to unexpectedly strang earth quakes or deterioration of the lumber used may prevent realization of such effectiveness In the event of an earthquake Immediately move away trom the organ When Moving the Organ Be sure to first disconnect the connection cord and remove the metal piate and the antl earthquake cabinet holder then carry the C 280P and the organ sepa rately Roland 40344201 40344201 Roland2. i Installing the Pipe System C 280P Make Sure that another person is on hand to help with the assembly and setup Ba very careful when lifting and moving the organ since It is quite heavy A Be very carelul when you assemble and move the organ to make sure that you do not drop it on your hands or feet To move the organ lift t carefully all the while keeping it level When assembling the organ and the pipe system do not apply excessive pressure on any part To do so can cause metal parts to get bent out of shape and may damage wooden parts e To prevent the pipe system from falling over use the anti earthquake cabinet holders to secure the unit to a wall surface Before Installing This Unit Before you begin check that all the parts were supplied o 9 Dowel x4 o o Metal Plate x 2 Screw a x4 Anti earthquake cabinet holder x 2 q Screw b x8 Setup Fasten each screw tightly This unit must be carefully placed so It s level and sure to remain stable Do not allow the speaker cord power cord or connection cord to get twisted or pinched while assembling tha C 280P Connect the C 280P only after confirming that the organ Is set up on flooring that Is both stable and level Remove the music stand before setting up the pipe system for instructions on j removing the music stand refer to the C 280 Organ Owner s Manual To prevent accidental falis and injury retrain from
3. stepping on or hanging from the organ brackets during or after Installation of the pipe system Remove the four caps found at the positions indicated in the figure of the organ s top panel 2 Insert the four dowels in the holes revealed when the caps are removed and screw down the dowels securely so that they do not shake or rattle within the holes 3 Align the four holes on the bottom surface of the pipe system with the four dowels protruding from the organ s upper panel then affix the pipe system making sure all dowels are fully inserted in the holes When setting up the pipe system grip the handle on the rear and the front of the side panel taking care not to allow your hand to become caught between the organ and the pipes Also make sure that the connection cord Is not pinched between the organ and the pipes pe Please don t get your fingers pinched 40344201 1 PD 4 Run the connection cord extending from the handle on the rear panel of the pipe system past the handle on the organ s rear panel then plug the cord into the pipe system connector at the bottom of the organ 5 Position the metal plate vertically across the rear panels of the organ and pipe system then fasten the plate with screws a Metal Plate Holes for the screws have not been provided Screw in the screws at the appropiate places 6 Move the entire assembly to the wall Then to prevent the system from falling over
Download Pdf Manuals
Related Search
Roland C 280P Pipe System Installation Guide