Home

drive sentra full reclining wheelchair Manual

1. Item STDRBIBDDA Shown For use with all Sentra Full Reclining Wheelchairs WEIGHT CAPACITY 300 LBS CAUTION Stability Wheelchair ic designed to he safe and stable az long a center of gravity ie maintained while going about normal activities Care must be taken while performing activities that shift yaur center of gravity in the chair Naver raach so far that require you ta chift in the seat or bend over out of the chair When you have to reach for abjacts that require you to lea be certain front casters are pointing in a forward position th extends the wheel base and will stabilize the chair Ramps Be sure of your own capabilities limitations and strength before attempting to go up a ramp Correct techniques on ramp negotiation should be shown to you by 8 qualified professional Assistance is recommended when Boing up or dawn inclines greater than 10 If you must stop an an incline avoid sudden abrupt movement when you resume movement Because of backward angle of the chair sudden abrupt movement could cause instability Attempting to use the whee lock brakes could result in accidental locking tipping to one side ar cause a sudden stop Avoid changing direction when going down an incline as this could result in inctabilty of tipping over Tic tlaat mliaalicxe warranty Your Drive brand product is warranted to be free of defects in materials and workmanship for the lifetime of the original consumer purch
2. STING ELEVATING LEG REST Lift foot plate on leg rest assembly to desired position Release leg rest assembly and it will automatically lock into place To lower push out on leg rest lever and lower foot plate to desired position WHEELS Large rear wheels should be inspected at least once a month to ensure proper tightness If wheel wobbles or is loose release lock nut and tighten axle bolt slightly Test for proper tightness by learning chair to one side and spin adjusted wheel GENERAL CARE Wipe chrome parts with a clean soft cloth at least once a week All metal parts can be cleaned with auto wax or similar poducts If exposed to moisture dry immediately Do not use an abrasive cleanser that will scratch the finish TO OPEN CHAIR Open wheelchair by tilting to one side and pushing down on seat rail until fully opened TO CLOSE FOLD CHAIR First fold foot plates to vertical position Grab seat with both hands at front and back edge and lift Or tilt chair to one side and lift up on seat rail REMOVABLE ARMS Remove arms by depressing spring button and lifting arms out of front and rear sockets WARNING Do not attempt to adjust or operate wheelchair without reading carefully al instructions in this manual This wheelchair has not been approved as a seat that can be used within vehicles of any kind Always transfer wheelchair user to a vehicle manufacturers approved seat and use safety restraints available Do not opera
3. are made by loosening or tightening nut on the carriage bolt Embed lock shoe at least 1 8 by sliding clamp toward rear wheel while handle is engaged in locked position Tighten nut and bolt to secure in position Test for correct locking action before actual use TIRES Solid rubber tires need minimal maintenance but should be cleaned occasionally with a damp cloth Replace if tires become severely worn or cracking appears FRONT CASTERS Casters should be checked periodically and lubricated occasionally Lubricate by removing fork and greasing caster stem bearings Lubricate wheel bearings by removing wheel from fork Reassemble fork and wheel by tightening nuts until no play remains but wheels roll freely IF nut is too loose caster will shimmy if too tight chair will be hard to steer REMOVAL OF SWING AWAY FOOT RESTS LEG RESTS Release lock by pushing on the front rigging lever Swing away foot rest leg rest out and sideways Lift to remove ADJUSTING LENGTH OF FOOTREST LEG REST When adjusting length of foot rests or leg rests user should be sitting in wheelchair with feet on the foot plates Loosen bolt on the clamp around support assembly Raise or lower foot plate to desired position that will provide maximum support of thighs Front rigging should not be so low that it causes uncomfortable pressure to thighs at front of seat upholstery Footrest should not be lower than 21 2 from the ground to ensure clearance ADJU
4. aser This device was built to exacting standards and carefully inspected prior to shipment This Lifetime Limited Warranty is an expression of our confidence in the materials and workmanship of four products and our assurance to the consumer of years of dependable service Inthe eventofa defect covered by this warranty we will at our option repair or replace the device This warranty does not cover device failure due to owner misuse or negligence or normal wear and tear The warranty does not extend to non durable components such as rubber accessories casters and grips which are subject to normal wear and need periodic replacement If you have a question about your Drive device or this warranty please contact an authorized Drive dealer drive Dive ia trade Medal Dep sntra full reclining wwwidrivemedical com Please read this manual carefully to insure safe usage and understanding of maintenance instructions Congratulations on your purchase of Drive wheelchair Drive wheelchairs are a product of quality engineering and are manufactured to meet our own highly rigid specifications and will surpass all your expectations WHEEL LOCKS Engage both wheel locks before getting in or out of chair leaning forward in chair or while in an elevator or wheelchair lft Proper adjustment of wheel lock is at least 1 8 when locked Locks are engaged by pushing handle completely forward Adjustments to locks
5. te this wheelchair on roadways streets or any surfaces with vehicular trafic Do not attempt to operate on inclines 10 or greater without proper assistance Be sure to completely engage wheel locks when getting in and out of wheelchair or when in elevator or wheelchair lift Wheelchair should be on a smocth stable and level area with wheel locks engaged before transferring user in or out of wheelchair Do not adjust foot rests any lower than 23 2 from Floor When getting in or out of wheelchair do not stand on or apply weight to foot rests Before reaching or leaning forward rotate casters to front of the wheelchair engage wheel locks ta help prevent wheelchair from tipping over Do not lean over or apply weight to the top of wheelchair back This can cause wheelchair to tip over When trying to extend arms over back only reach as far as your arm can extend without having to alter your seating position DO NOT stand on wheelchair DO NOT use wheel locks to slow your descent down an incline Abruptly changing directions while going dewn an incline could cause instability or possible tipping over

drive sentra full reclining wheelchair Manual

Contents

Download Pdf Manuals

Related Search

Related Contents