Uniden BTS150 High-Definition Speaker User Manual
Contents
1. SPECIFICATIONS Total 4W output 2W Channel Full range 35 mm driver Channel Passive Radiator Li lon Batt 1180mAh Playtime Up to 5 hours in 80 Volume Recharging Time 7 5 hours Range Class 2 10m Compatibility Bluetooth 2 0 or above device with A2DP AVRCP HFP HSP 16 English Safety and Handling Information For maximum product life do not drop throw or crush the speaker Do not expose it to humidity dust or temperatures above 125 F FCC Notice This device complies with part 15 of the FCC rules Operation is subject to the following two conditions 1 This device may Not cause harmful interference and 2 This device must accept any interference received including interference that may cause undesired operation Privacy of communications may not be ensured when using this product Note This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception2. Ll to connect to A2DP amp HFP disconnection of A2DP HFP successfully 14 English If this happens Try this Sound is not clear or there is no sound at all Turn your speaker off and then back on Turn off your music device s equalizer Check your speaker or Bluetooth device volume level Music won t play on the BTS150 Make sure your Bluetooth device has A2DP Check if both devices are connected Turn your speaker off and then back on to auto connect with your Bluetooth device The BTS150 volume controls are not working Change the volume from your Bluetooth device If your music device is wired into your speaker you cannot change the volume through the speaker Check the battery level LED No Power Make sure your speaker is turned on Make sure your speaker is charged Sound is too small too much distortion Adjust your speaker or Bluetooth device volume level Turn off your Bluetooth device s equalizer English 15 If this happens Try this Phone call not answer by Make sure your cellphone has HFP BTS150 Verify that both devices are connected Restart your speaker to auto connect with your Bluetooth device Music doesn t play after Press Cio resume music hanging up a call BTS150 doesn t control the Make sure your Bluetooth device has AVRCP music
3. than as detailed by the owner s manual for this product STATEMENT OF REMEDY In the event that the product does not conform to this warranty at any time while this warranty is in effect warrantor will either at its option repair or replace the defective unit and return it to you without charge for parts service or any other cost except shipping and handling incurred by warrantor or its representatives in connection with the performance of this warranty Warrantor at its option may replace the unit with a new or refurbished unit THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER WHETHER EXPRESS IMPLIED OR ARISING BY OPERATION OF LAW INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL DAMAGES Some states do not allow this exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you LEGAL REMEDIES This warranty gives you specific legal rights and you may also have other rights which vary from state to state This warranty is void outside the United States of America and Canada English 19 PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY If after following the instructions in the owner s manual yo
4. the second Bluetooth device 1 Turn on your speaker 2 Press and hold until your speaker beeps twice 3 4 Follow the same procedures for pairing your first Bluetooth device see page 5 Release O The BTS150 is ready to pair 6 English GETTING TO KNOW THE BTS150 SPEAKER BTS150 Top REVERSE FORWARD f TALK PLAY E UP D aa POWER DOWN LEDs 2 Key name Icon Press to REVERSE 144 Rewind or skip back in music Turn your BTS150 speaker on off POWER e Press and hold to register devices DOWN Decrease the volume FORWARD BE Fast forward or skip ahead in music English 7 Key name Icon Press to Handle phone calls and play music TALK PLAY LC Press and hold to register devices NOTE This key can also turn your BTS150 speaker on and off UP Increase the volume BTS150 Back Main Power USB Charge 3 5 mm Switch Port Audio In Use this To Main power switch turn main power on and off USB charge port 8 English connect your speaker to the AC adapter Use this To 3 5 mm Audio In connect non Bluetooth devices LEDs Two LEDs on the front of your speaker provide visual cues to different processes Color State Meaning On Power is on Blue Slow flash Battery is charging Flashing Fast flash Lost Bluetoo
5. Uniden BTS150 High Definition Speaker Haut parleur haute d finition BTS150 Questions Problems Get help on the web at www uniden com or call our Customer Service line at 800 292 2294 Questions Probl mes Obtenez de l aide au www uniden com ou en communiquant avec le soutien la client le au 800 292 2294 Table of Contents Important Safety Instructions BTS150 HIGH DEFINITION SPEAKER 3 What s Included SET UP YOUR BTS150 SPEAKER Charge the Battery Turn on Your Speaker 5 Pair Bluetooth Devices to Your SPEAKEF nee 5 GETTING TO KNOW THE BTS150 SPEAKER 7 BTS150 Top 2 English BTS150 SPEAKER OPERATION Basic Cell Phone Operation 10 Basic Music Operation SPECIAL FEATURES Play Music through a Wired CONNECTION mn 13 SPECIFICATIONS Compatibility One Year Limited Warranty 18 Important Safety Instructions Do not use this product near water for example near a bath tub wash bowl kitchen sink or laundry tub in a wet basement or near a swimming pool Do not use this product while driving Use only the power cord and batteries indicated in this manual Do not expose the battery or the device to flames or dispose of it in a fire the battery may explode Check with local authorities for possible battery disposal instructions Do not disassemble modify or attempt to repair any component of this product Check the laws and regulatio
6. aired to your speaker The LC LED flashes and your speaker sounds an alert tone Your cellphone must subscribe to Call Waiting service to use these features contact your telephone provider for more information To Do this Answer a call waiting call and put first call on hold Press and release Ll twice The existing call is put on hold and the second call is now active Switch between current call and calls on hold Press and release L twice The current call is put on hold and the call on hold is now active English 11 To Do this Answer a call waiting call Press Ll the first call is ended and the call waiting call is and hang up first call now active Basic Music Operation When you pair a Bluetooth music player to your speaker you can control operation through your speaker To Do this Press Ll A Play music NOTE When you stop or pause the music playback the music resumes at the same volume level after you press Skip to the next track Press PPI Fast forward Press and hold PPI Skip to the previous P p Press track Rewind Press and hold 144 12 English To Do this Control the volume Press to increase or to decrease the volume Pause music Press l while the music is playing Stop playing music Press and hold Ll while the music is playing SPECIAL FEATURES P
7. ing instructions for satisfying RF exposure compliance To maintain compliance with IC RF exposure compliance requirements please follow operation instruction as documented in this manual Lithium lon battery information This device contains a non removable lithium ion battery The battery must be recycled or disposed of properly Contact your local waste management office for information on battery recycling or disposal One Year Limited Warranty Evidence of original purchase is required for warranty service WARRANTOR UNIDEN AMERICA CORPORATION Uniden ELEMENTS OF WARRANTY Uniden warrants for one year to the original retail owner this Uniden Product to be free from defects in materials and craftsmanship with only the limitations or exclusions set out below 18 English WARRANTY DURATION This warranty to the original user shall terminate and be of no further effect 12 months after the date of original retail sale The warranty is invalid if the Product is a damaged or not maintained as reasonable or necessary b modified altered or used as part of any conversion kits subassemblies or any configurations not sold by Uniden c improperly installed d serviced or repaired by someone other than an authorized Uniden service center for a defect or malfunction covered by this warranty e used in any conjunction with equipment or parts or as part of any system not manufactured by Uniden or f installed or programmed by anyone other
8. lay Music through a Wired Connection You can still play music through your BTS150 speaker even if your music device is not paired to your speaker You can physically connect your music device to your speaker with a 3 5 mm minijack cable not included 1 Plug one end of the cable into your music device just like you would a pair of headphones 2 Plug the other end of the cable into your speaker s 3 5 mm jack labeled AUDIO IN 3 Use your music device to start and control music playback and volume through your speaker English 13 The following restrictions apply when you are playing music through a wired connection If both a Bluetooth device and a wired device are connected to your speaker the Bluetooth device will take priority over the wired device The BTS150 does not control the wired device it only plays music through a wired connection Ifyou are listening to music from the wired device and you press l your speaker will start playing music from the Bluetooth device if available TROUBLESHOOTING If this happens Try this Disconnection due to Out of Move back into connection range and Range Turn your speaker off and back on to reconnect to your Bluetooth device Press g for reconnection NOTE The speaker automatically connects to the last device connected If you need to reconnect to the first device that was connected power off and back on No Beep sound after Press and
9. ns on the use of mobile phones and hands free equipment in the areas where you drive Always give full attention to driving and pull off the road and park before making or answering a call if driving conditions require SAVE THESE INSTRUCTIONS Bluetooth BTS150 HIGH DEFINITION SPEAKER Uniden s BTS150 high definition Bluetooth speaker provides clear stereo sound in a compact portable package With Bluetooth V2 0 compatibility the BTS150 pairs with your cell phone to become a speakerphone for hands free conversations You can also connect your music player wired or wireless for crisp clear audio English 3 Bluetooth V2 0 Up to 2 Bluetooth devices can be paired with your speaker Supporting A2DP AVRCP HFP HSP profiles Portable Upto 5 hours of play from a fully charged battery Up to 33 ft 10 m e Call Waiting feature The BTS150 speaker is not a data storage device do not attempt to copy files to it What s Included BTS150 Speaker AC Adapter ZDA050100US with USB cable SET UP YOUR BTS150 SPEAKER Charge the Battery 1 Slide the main power switch to the ON position see page 8 2 Insert the adapter s mini USB connection into your speaker s USB slot see page 8 3 Plug the adapter into your computer 4 English 4 The LEDs flash blue while the battery is charging charge time 7 5 hours ona completely empty battery The LEDs turn solid blue when the battery is fully charged Your ba
10. th connection On Bluetooth is connected but the battery level is low neg Flashing Power almost gone and Bluetooth is not connected Blue and Red Flashing Pairing mode LED off Power is off English 9 BTS150 SPEAKER OPERATION When you want to turn on your speaker remember to slide the main power switch to the ON position Press and hold D for at least 3 seconds The and mmm keys control the speaker s volume level during cellphone operation and music playback Press and release the keys to increase or decrease the volume level one step at a time Press and hold and mam to quickly raise and lower the volume levels Your speaker sounds an alert tone when it reaches the maximum upper and lower volume levels Basic Cell Phone Operations When you have an incoming call the speaker sounds an incoming call tone and the LEDs flash blue Both the speaker and your cellphone may ring depending on your cellphone settings To Do this Answer an incoming call Press any key Reject an incoming call Press and hold l End a call Press L 10 English To Do this Switch between your speaker and your cellphone Press and hold L during an active call Redial the last incoming number From standby press L twice Redial the last number dialed From standby press and hold Ll Call Waiting You can receive call waiting notification when your cellphone is p
11. ttery must be fully charged before you can use your speaker Turn on Your Speaker When you turn on your speaker for the first time it automatically goes into pairing mode The LEDs rapidly flash red and blue while in pairing mode After you pair Bluetooth devices to your speaker the next time you turn it on it searches for these paired devices and then moves into a standby state 1 Slide the main power switch to the ON position 2 Press and hold for at least 3 seconds A power on tone sounds 3 The LEDs flashes blue and red slowly while looking for Bluetooth devices It remains steady on blue when Bluetooth devices are discovered otherwise it keeps flashing Pair Bluetooth Devices to Your Speaker Make sure your speaker has been fully charged and is in pairing mode Pair First Bluetooth Device Pair your first Bluetooth device to your speaker when you turn your speaker on for the first time Be sure your speaker is in pairing mode see page 6 1 Select a Bluetooth V2 0 device mobile phone or music player to pair English 5 Select the Searching mode on your Bluetooth device refer to your Bluetooth device s owner s manual for details if necessary Your Bluetooth device should find BTS150 select it and use 0000 for a pairing code if necessary Verify that you are connected to your speaker The Bluetooth LED moves to a steady ON state when pairing is complete Pair Second Bluetooth Device When you want to pair
12. u are certain that the Product is defective pack the Product carefully preferably in its original packaging The Product should include all parts and accessories originally packaged with the Product Include evidence of original purchase and a note describing the defect that has caused you to return it The Product should be shipped freight prepaid by traceable means to warrantor at Uniden America Service 4700 Amon Carter Blvd Fort Worth TX 76155 20 English
13. which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio TV technician for help Any changes or modifications not expressly approved by the party responsible for compliance could void the user s authority to operate this device English 17 To insure the safety of users the FCC has established criteria for the amount of radio frequency energy various products may produce depending on their intended usage This product has been tested and found to comply with the FCC s exposure criteria Use of other accessories may not ensure compliance with FCC RF exposure guidelines and should be avoided Industry Canada statement This device complies with RSS 210 of the Industry Canada Rules Operation is subject to the following two conditions 1 This device may not cause harmful interference and 2 this device must accept any interference received including interference that may cause undesired operation IMPORTANT NOTE Radiation Exposure Statement This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment End users must follow the specific operat
Download Pdf Manuals
Related Search