YAMAHA RS-80 Electronic Drum Rack System Assembly Instructions(1)
Contents
1. Electronic Drum Rack System YAMAHA oS S Assembly Instructions Thank you for purchasing the Yamaha Electronic Drum Rack System RS 80 Before using thoroughly read this assembly manual and use this product safely and correctly E RS 80 Rack Stand Parts E RS 80 Pad grouping Set up example Before assembling the rack stand make sure all of the parts shown below are included A Left Side Assembly x1 Right Side Arm x1 m p aa C Right Side As sembly x1 Drum Pad Clamp Short x2 CHO Drum Pad Clamp Long x3 Center Bar x1 Ge HO Pad and Drum Trigger Grouping option DTX TP80S TP80 PCY80S PCY80 Cymbal Holder x2 Drum Trigger Module Drum Pad Cymbal Pad Module Holder x1 4 screws included zn U Cable Band x10 BRB a ae lt KP80 Foot Pedal Kick Pad FP 820 etc Tuning Key x1 Assembly Instructions m this sheet H Hex Rod Cylinder x6 Specifications are subject to change without notice YAMAHA YAMAHA CORPORATION Printed in Taiwan E RS 80 Assembly A screw driver or is necessary to complete the assembly Over tightening of the fixin2. g bolts may result in damage Take care when tightening fixing bolts and screws Insert the Right Side Assembly C pipe into the Right Side Arm B and tighten the fixing bolts Insert the Left Side Assembly A pipe and the Right Side Assembly C pipe into the Center Bar E and tighten the fixing bolts Make sure that the Left and Right Side Assemblies are not reversed Above the Center Bar E attach the Center Pipe D and tighten the fixing bolts Attach the Center Pipe D Center Bar Left Side Assembly a Attach the Module Holder Insert the Hex Rod Cylinder H into the Module Holder Clamp G and tighten the fixing bolts 4 2 Attach the Module Holder Clamp G to the Left Side Assembly A pipe Attach the DTX to the Module Holder F With a screwdriver use the screws included with the Module Holder to attach the holder to the bottom of the DTX Attach the Module Holder F with the DTX attached to the Module Holder Clamp G DTX Module Holder 7 Step 4 3 Hex Rod Cylinder 4 2 Attach the Module Holder Left Side Assembly A 5 Attach the Drum Pad Clamps Insert the He
3. he way while playing use the supplied Cable Bands to hold the cables to the rack systems s pipes
4. x Rod Cylinders H into the Drum Pad Clamps L J and tighten the fixing bolts Attach the Drum Pad Clamps Short 1 to the snare drum and floor tom positions The Drum Pad Clams Long J should be attached to the hi hat and tom tom positions Insert the Hex Rod Cylinders H in the pads adjust the posi tion of the pad and tighten the fixing bolts 6 Attach the Cymbal Holders Insert the Cymbal Holders K into the Cymbal Holder Clamps that are attach to the left and right sides of the Center Pipe D and tighten all fixing bolts Attach the Cymbal Pad to the Cymbal Holders Kk adjust the position and tighten the fixing bolts Refer to the Cymbal Pad s Owner s Manual for instructions on attaching the cymbal pad to the cymbal holder Step 6 2 f a Cymbal Pad i Step 5 1 Drum Pad Clamp V Long J Hex Rod Cylinder Cymbal Holder A Cymbal Holder Drum Pad Clamp Long J a Ga Step 6 1 LES ae ret Toe lt Drum Pad AT Clamp short fj 2 Drum Pad Clamp short Li After the above assembly is complete set the Kick Pad Hi Hat Con trol Pedal etc into position and connect the necessary cables To keep cable out of t
Download Pdf Manuals
Related Search
YAMAHA RS 80 Electronic Drum Rack System Assembly Instructions(1)