YAMAHA NS-C200 Manual
Contents
1. dome tweeter Nominal Impedance cceeecceceeeneecereeeeseeeeeeeeseeeneenenenenes 6 ohms Frequency Response cseccceescseeeseeeeeeeeeerseneees 57 Hz 35 kHz Nominal Input POWET cseccceeseneeeeeeeeereeneeeeeeeeeneeeeeeseeeees 100 W Maximum Input POWE 0 eee eeeeceeeeeeeceenneeeeeeeeeeneeeeenaeeeeeneees 300 W SEMSIIVILY2 cnnceccc sentence anne ainsate in iita sae anana 90 dB 2 83 V m Crossover FreQuency sssrin iniiiiosi neiniernrinniaksra rinrin eikon ia 3 kHz Dimensions W x H X D aasssasssssrserrrnsrsserrenn 500 x 168 x 201 mm Weight iernii decd ctu deecned lene iasaiten nae aa aE SA aiat 7kg ACCOSSONY ic ivcsesteesieccxctcnnetenesdstentaedeedbectaevaviee te Velcro strips 4 sets e Specifications subject to change without notice due to product improvements e Care should be taken not to exceed the input power values noted above YAMAHA CORPORATION V5566202. English YAMAHA NS C200 OWNER S MANUAL Speaker System Thank you for selecting this YAMAHA NS C200 speaker system PRECAUTIONS Read these precautions carefully before using your speaker e Do not place the speaker where it is liable to be knocked over or e Any time you note distortion reduce the volume control on your struck by falling objects Stable placement will also ensure better amplifier to a lower setting Never allow your amplifier to be sound performance driven into clipping Otherwise the speaker may be damaged e Placing the speaker on the same shelf or rack as the turntable e When using an amplifier with a rated output power higher than can result in feedback the nominal input power of the speaker care should be taken e When positioning the speaker be sure to leave some space never to exceed the speaker s maximum input between the speaker and the wall or other hard surface e Do not attempt to clean the speaker with chemical solvents as e Secure placement or installation is the owner s responsibility this might damage the finish To clean wipe with a dry soft cloth YAMAHA shall not be liable for any accident caused by improper e To prevent the enclosure from warping or discoloring do not placement or installation of the speaker place the speaker where it will be exposed to direct sunlight or excessive humidity PLACING THE SPEAKER Place the center speaker on top of the TV on the floor un
3. der the TV or inside the TV rack so that it is stabilized When placing the center speaker on top of the TV to prevent the speaker from falling down put the supplied velcro strips at four points on both bottom of the speaker and top of the TV The center speaker should be set in alignment with the center of the TV screen The positioning of the center speaker is important because it controls the whole sound quality of a multi channel system Set up the center speaker on the basis of your listening position by following the owner s manual supplied with your amplifier Velcro strip Notes e Do not place the center speaker on top of the TV whose area is smaller than the bottom area of the speaker If placed the speaker may fall and possibly cause damage or personal Front Effect injury Speakers e Though this speaker is magnetically shielded there may be some influence on the TV picture depending on the type of TV or the placement of the speaker In such a case place the speaker away from the TV so that there is no influence on the TV picture Rear Speakers CONNECTIONS TO YOUR AMPLIFIER REMOVING THE FRONT COVER Before making connections make sure that the amplifier is switched off Loosen Black Red Center speaker O e e CENTER Amplifier or Receiver E Connections e Connect the screw type input terminals at the rear of the speaker to the s
4. peaker output terminals of your amplifier with the speaker cables e Connect the terminals on both the amplifier and the speaker using one side of the cable Connect the terminals on both components using the other side of the cable e Connect the speaker to the center terminals of your amplifier making sure not to reverse the polarity If this speaker is connected with reversed polarity the sound will be unnatural and lack bass Procedure Loosen the terminal knob Remove approx 10 mm insulation from the speaker cable and insert the bare wire end properly into the terminal hole Tighten the knob Test the security of the connections by tugging lightly on the cable at the terminal Note Do not let the bare speaker wires touch each other as this could damage the speaker and or the amplifier The front cover is fastened to the enclosure at four points and can be removed if desired To remove the cover hold on to both sides and slowly pull straight away from the speaker To reattach line up the four pegs on the inside surface of the cover with the four corresponding holes on the speaker and push gently Note When the cover is removed take care not to touch the speaker units with your hands or to exert excessive force with tools SPECIFICATIONS TYPO eisir 2 way 3 speaker bass reflex speaker system Magnetically shielded type BINE AE ide dren antes 13 cm cone woofer x 2 3 cm
Download Pdf Manuals
Related Search
YAMAHA NS C200 Manual yamaha ns-200 yamaha ns-200ma yamaha ns 200m speakers yamaha ns-200m ns 200 service manual yamaha ns-c120 yamaha ns-sw200 yamaha ns-2000 ns-2000a yamaha yamaha ns-c210 ns speaker yamaha manual yamaha ns-2000a review yamaha ns 2000 speakers manual ns 200 fi yamaha ns-c210b yamaha ns sw 200 ns 200 engine specs ns-c200 ns 200 new model yamaha ns-2 yamaha ns a200xt speakers yamaha ns 2000a speaker reviews ns 200 new version yamaha ns-20